Double click to change text

How to Make a Smart Cap For Your Bathmate (& make pumping outside the bathroom forever easier) More at PumpyDingDong.com You Will Need:

SMART WATER BOTTLE

DUCT TAPE

UNIVERSAL PUMP SLEEVE

You will also need an xacto knife, scissors, or razor sharp teeth (if you have them). A rubber band is handy, but optional.

AND GRAB A MEASURING CUP. TO PUT WATER IN.

A rubber band can be used to help guide you as you cut. Tape would ork too. Come to think of it, you could just complete the mark round the whole bottle... oh well, too late now.

PART 1 Fill up a measuring cup to the 1 Cup line.

Pour it into the smart water bottle, put cap on and turn upside down. Mark the water line.

PART 2 Cut around the banded line, being very careful as to not sever an artery, as that would reflect poorly on your bathmate results. Apply tape around the cup like so.

Fold in the overlapping edges.

PART 3 Fit the small end of the universal pump sleeve around the nozzle of the pump. It will leak if there are creases or folds.

Fit the large end of the universal pump sleeve around the cup.

Slide it over the top and that's it - you're done!

Using This Mod 1. Take bottle cap off when filling, for easy access to the nozzle 2. After putting on the bathmate and getting a seal, put the cap on 2/3rds of the way so that air can freely flow out, but water will stay in 3. When you you need to release pressure; pushing down on the cap will force the pressure release valve on the bathmate to open