Headlight Installation Guide for the VW Golf 7 Caution – Please review the installation guide prior to installing the lights. If you are uncomfortable with doing this, please seek professional assistance. Take your time, excess force will break the plastic tabs on your car and you can scratch the paint if you are not careful. Procedures 1. Remove the two T25 Torx screws from the grill and pull the grill up which is under pressure in the bumper. Pull the grill towards your direction to unsnap it from that other plastic behind it. When you unsnap it and the front grill is loose, you need to move it up to disconnect it from the bumper.

2. Remove screws from the fender well and under the bumper. There are four in the wheel well, and two under the bumper cover.

3. Remove the three T30 screws from the headlight housing assembly.

4. Remove screws holding the plastic cover and remove the plastic cover as one piece.

5. Remove the side screws from the headlight assembly.

6. Now remove the wire harness from the headlight (just push the latch plug with your hand and pull). A small flat blade screwdriver may help. Excess force WILL damage it. 7. Pull the bumper cover FORWARD so you can remove the headlight. Remove the headlights. There are clips hold it in place.

8. In the original headlight housing there are two round screws that need to be removed and installed into the new headlight. it and install into the new headlight

9. The HID Ballast can be tucked under the headlight housing, you can screw the ballast to the housing if you want to keep it more secure.

10. The front of the headlight housing has a screw that needs to be installed before you put the grill back on. Don’t forget.

11. For aiming the headlights, they can be adjusted both vertically, and horizontally. If you hear clicking, you have reached the maximum limit, excess turning can damage the adjusters. You may have to do a combination of vertical and horizontal movements to get the projector into the right position.