Tire Pressure Sensors User Guide Installation Steps 1)

Set up your RVibrake2 in your towed vehicle. (See your RVibrake2 Instruction Guide for Installation steps)

2)

Run RVibrake2 through the Auto Start process. (See your RVibrake2 Instruction Guide for Installation steps)

3)

Using the Wireless Monitor in the coach press the Menu button until you see Enable TPS and press the Up Arrow button. This will make RVibrake2 ready to pair with the Tire Pressure Sensors.

4)

Thread the Tire Pressure Sensors onto the valve stems of the tires on your towed vehicle. You can put them on in any order. Just make sure that you are putting the sensors on the corresponding tires. (Ex. LF Sensor will go on the front driver side tire or Left Front tire.)

5)

The sensors will pair quickly. The Wireless Monitor will give you confirmation that they are paired. To see the individual pressures for each tire press the Menu button.

Uninstall Tire Pre ssure Se nsors To uninstall the Tire Pressure Sensors: 1. Unthread the sensors from the tires. 2. On the Wireless Monitor go through the Menu until you see Disable TPS and disable. Note: Removing the sensors in the off-season will prolong the life of the batteries in the sensors.

Wireless Monitor Warnings & Messages Message

Description

TPS Low Pressure

TPS LOW PRESSURE displays on the Wireless Monitor. The tire has reached the Low Pressure point. The default for Low Pressure is 25 PSI. You can manually change the Low Pressure point in the menu to your preference.

TPS Zero Pressure

An audible alarm sounds from the Wireless Monitor, with TPS ZERO PRESSURE. A tire(s) is flat. Pull over immediate to replace the tire on the towed vehicle.

High Temp Alert

An audible alarm sounds from the Wireless Monitor, with HIGH TEMP ALERT. A tire(s) has reached 170˚ degrees or higher. Call RVibrake Customer Service 800-815-2159.

121712

2

Fre que ntly Aske d Que stions Why do I need it? Q. Why do I need Tire Pressure Sensors? A. To know exactly when a tire is low or flat. This prevents you from not knowing that you are ruining your rims and rotors.

Physical Design Q. Will the Tire Sensors fit in my tire stems? A. Yes. The Tire Sensors are ultra-lightweight and work with aluminum, rubber, and steel tire stems

Installation Q. How long does it take to install the Tire Pressure Sensors? A. Installation and removal can be done in under a minute.

Engineered Design Q. How do the Sensors communicate from the back tires to the front of the coach? A. The Tire Sensors only have to transmit a few feet to the RVibrake2 in the towed vehicle. The RVibrake2 then relays the signal up to the front of the coach with it’s long range antenna.

Troubleshoot Q. How do I know Tire Sensors are working? A. RVibrake2’s wireless monitor (plugs into the motor home) gives complete, continuous information on the sensors. You can see your pressures at any time by pressing the Menu button on the monitor. Note: Even if the wireless monitor is not plugged in, the Tire Sensors will continue to work.

121712

3

Com pliance Antenna Usage This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. FCC radiation Exposure Statement to comply with FCC RV exposure requirements in section 1.1307, a minimum separation distance of 0.81 cm (0.3 inches) is required between the antenna and all persons. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: a) Reorient or relocate the receiver antenna. b) Increase the separation between the equipment and receiver. c) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. d) Consult the dealer or an experienced radio/TV technician for help. The Installer of this radio equipment must ensure that the antenna is located or pointes such that it does not emit RV field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website http://www.hc-sc.gc.ca/rpb IMPORTANT: Changes or modifications not expressly approved by Danko Manufacturing LLC could void the user’s authority to operate the equipment.

121712

4

Warranty Limited Three year Warranty A three-year limited warranty and a 30-day money back guarantee, apply to your RVibrake and RVibrake accessories. Wha t is c ov e r e d a nd for how long? RVibrake is warranted for three years of original purchase date to the original retail purchaser. It warrants your product to be free of mechanical and electrical defects in material and workmanship. Whe r e or how do I ge t a s s is ta nc e for m y R Vibr a k e ? During the warranty period, RVibrake will repair or replace the product (at RVibrake’s discretion), which will be your exclusive remedy under this warranty. Do NOT return the product, doing so may delay the processing of your claim and the repair or replacement of the product. For return instructions, please call RVibrake Customer Service found on page 6. Wha t is not c ov e r e d? The warranty will not cover damage resulting from neglect or misuse of the product, use contrary to operating instructions, or disassembly, repair, or alteration by any person other than RVibrake’s repair department. RVibrake is not liable for any incidental or consequential damages for breach of any expressed or implied warranty on the product. H ow s ta te la ws m a y a pply Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitation may NOT apply. This warranty gives specific legal rights, and you may also have other rights, which vary from state to state. “This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

121712

5

Contact Inform ation RVibrake Customer Service 1-800-815-2159

Address 624 Atchison Way #103 Castle Rock, CO 80109

Website http://www.rvibrake.com

121712

6