SERVICE

Whirlpool Europe Customer Services

AVM 510

Service Manual Microwave oven AVM 510 Model Version

AVM 510 8538 510 53220

Page

Introduction safety

2

Technical data

3

Spare part list

4

Exploded view

5

Wiring diagram

6

This documentation is only intended for qualified technicians who are aware of the respective safety regulations. Date: 20.03.1996 Subject to modification Document-No.: 4812 714 10788

20.03.1996 / Page 2 Doc. No: 4812 714 10788

Whirlpool Europe Customer Service

SERVICE

Introduction safety INTRODUCTION Before leaving the factory each oven is carefully checked. It must, however, be installed and used correctly. Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact the user understands how to use and maintain the oven. The information in this section should be used as a reminder that the oven is safe and that anyone who uses it must first read the instructions for use in order to be able to use the oven correctly and obtain best results. SAFETY To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven. Always disconnect the plug from the mains before starting work. If there is no plug switch off the electric supply at the control box. When you have finished servicing an oven before you reconnect it to the mains, make sure that: - all the internal connections are correct - the wires are insulated and not touching the door or the cabinet or anything sharp - all the earth connections are electrically and mechanically sound - do not modify or anyway interfere with the safety devices built-in to the oven - make sure that each replacement part you use conforms to the manufacturer´s specifications Do not start a repair if you have any doubt as to your ability to complete it. CAUTION - MICROWAVE RADIATION PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE MAGNETRON, WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE. NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED. NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED. NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE AROUND MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS). Do not operate the oven if the following conditions exist: - the door does not close firmly against the door support because of the door being warped or the hinges damaged. - The door trims or seals are damaged. - If there is any visible damage to the oven. - if the door does not close properly. Avoid operating the oven if known components in the interlock system, oven door or microwave generating assembly are known defective. They must be replaced. WARNING - HIGH VOLTAGE IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH HV TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRIC MEASUREMENTS INSIDE THE OVEN.

SERVICE

Whirlpool Europe Customer Service

20.03.1996 / Page 3 Doc. No: 4812 714 10788

Technical data Dimensions of cabinet Height Width Depth

Electrical 298 492 359

mm mm mm

190 300 300 22

mm mm mm l

Voltage Power consumption Current consumption Fuse

230 1330 6 8

V W A A

850

W

60

min

Dimensions of cavity Power Height Width Depth Cavity volume Weight Net Packed

Output power Timer Mechanical

16,3 18,6

Kg Kg

Accessories Glass tray, turntable ring

20.03.1996 / Page 4 Doc. No: 4812 714 10788

Whirlpool Europe Customer Service

SERVICE

Spare part list Model Service No. Version

AVM 510 853851053220 853851053220

Pos. No. 12NC Code

Description

Pos. No. 12NC Code

Description

001 1 001 2 001 3 002 0 002 2

4819 902 00031 4819 902 00176 4819 902 00025 4819 902 00172 4819 902 00082

Spacer Lever Spring,tension Lid Cover

406 0 406 1 406 2 406 3 412 0

4819 902 00271 4819 902 00179 4819 902 00174 4819 902 00272 4819 902 00204

Motor Cover Cover Gasket Transformer,HT 240V

002 3 002 4 013 0 013 1 013 2

4819 902 00049 4819 902 00051 4819 902 00115 4819 902 00055 4819 902 00056

Stamper Bushing Foot Pin foot Cap foot

412 0 412 1 420 0 420 1 421 0

4819 902 00285 4819 902 00029 4819 902 00065 4819 902 00177 4819 902 00126

Rubber shock-proof spacer Guide Capacitor,HT Support Control unit

041 0 042 0 042 1 121 0 121 1

4819 902 00274 4819 902 00273 4819 902 00183 4819 902 00282 4819 902 00284

Support Support Plate Door inner Frame inner

421 1 425 0 426 0 426 1 442 0

4819 902 00058 4819 902 00215 4819 902 00209 4819 902 00122 4819 902 00207

Support Resistor Diode Diode Motor,fan

130 0 131 1 131 2 131 3 131 4

4819 902 00228 4819 902 00013 4819 902 00014 4819 902 00283 4819 902 00037

Switchmechanism Pin Spring Hook Pivot

442 1 442 2 442 3 443 0 485 2

4819 902 00178 4819 902 00052 4819 902 00019 4819 902 00276 4819 902 00047

Support Bushing Screw Fan wheel Clip

133 0 133 1 141 0 142 0 143 0

4819 902 00035 4819 902 00036 4819 902 00187 4819 902 00034 4819 902 00198

Lockingmechn. Lockingmechn. Oven glass outer Foil door inner Door frame outer

490 0 503 0 527 0 561 0 562 0

4819 902 00242 4819 902 00073 4819 902 00216 4819 902 00071 4819 902 00237

Cable,mains W/SAA plug Timer Control unit Thermostat magnetron Thermostat

255 0 264 0 264 1 264 2 320 0

4819 902 00218 4819 902 00192 4819 902 00195 4819 902 00193 4819 902 00277

Turntable Ring Wheel Shaft Cover

617 0 617 1 632 0 633 0 651 0

4819 902 00214 4819 902 00094 4819 902 00077 4819 902 00078 4819 902 00275

Relay Support Switch Switch Lamp

332 0 332 1 334 0 334 1 404 0

4819 902 00279 4819 902 00281 4819 902 00278 4819 902 00095 4819 902 00063

Button,push Spring,compres. Knob Bushing Magnetron

651 1 652 0 901 0 971 0 971 1

4819 902 00219 4819 902 00079 4819 902 00197 4819 902 00217 4819 902 00269

Cover,lamp Holder,lamp Cable clamp (T) Fuse Clip

971 2

4819 902 00235

Holder,carb.br.

SERVICE Exploded view

Whirlpool Europe Customer Service

20.03.1996 / Page 5 Doc. No: 4812 714 10788

20.03.1996 / Page 6 Doc. No: 4812 714 10788

Wiring diagram

Whirlpool Europe Customer Service

SERVICE