Fat Quarter Place Mat Tutorial By: Lori Suss, February 13, 2013 Following this tutorial, you will be able to make 6 placemats and a table runner. All you need are 6 coordinating fat quarters, and some additional yardage for backing and binding.

1. From each of the fat quarters cut a 12 ½” x 20" rectangle. (Save the remaining strip for the table runner.) Arrange them in a pleasing order with good contrast between the colors.

2.

Stack them together all with the right side up. (If you have directional prints, make sure they are facing the same way. I forgot to double check mine!)

3.

Make your first cut through all layers on the diagonal.

4.

Make the second cut parallel to your first, 5 ¼” down to the lower right corner.

5. The long diagonal should measure approximately 23 3/4". Mark the center point of the upper left piece at 11 7/8". Make your third cut from the corner to your mark.

6. Cut parallel to your last cut, 4 1/2" on each side.

7. To rearrange your fabric so all the place mats contain one piece of each fabric take one piece of fabric from the pile labelled "1" and move it to the bottom of the stack.

8. Move 2 pieces to the bottom of pile two, 3 pieces to the bottom of pile three etc.

9. Because seam allowances have not been included, your place mats are going to be a little wonky when first put together, but they will be trimmed up in the end. (Here you can really see that the fabric with the white background was upside down when I stacked my fabrics.)

10. Using the top layer of fabric in each pile, pin pieces in pairs, being sure to have to 1/4" tail sticking out as shown in the yellow circles. This will allow the right hand side and the long diagonal to have straight edges. You are working with bias edges, so be careful not to stretch them out of shape as you sew and press.

11. Finally join the long diagonal seam. Have the 1/4" extend at the top right hand corner. The bottom left hand corner will not match up at this point.

12. Trim place mat to 11" x 17 ½”.

13. Trim the leftover fat quarter strips to 5" if you have a larger table or varying widths to fit your table. I used from left to right: 5", 2 ¼”, 5", 3 ¼ ", 5", 2 ¼”, 5"

14. Sew your strips together.

15. Trim to a size that fits nicely on your table, for me that is about 15" x 25".

16. Quilt and bind with your favorite methods. I decided to take this opportunity to test out some different quilting designs and decided to quilt each one differently. I was a great exercise to see what I would like to do on a larger piece.

Adapted from original tutorial at http://nightowlquilting.blogspot.ca/2013/02/fat-quarter-place-mat-tutorial.html