Jewellery Bag Tutorial By Creating my way to Success

These bags are easy to make – and perfect for jewellery with their small individual pockets inside:

First you need to make your pattern. You need two circles – one large and one smaller. I used a serving dish and plate from the kitchen to draw around.– My larger circle is approx. 31cm (12”) in diameter, and the smaller is 22cm (8.5”) in diameter. This will make a finished bag around the size of the palm your hand – but you can make any size you choose! Cut these two circles out of paper:

www.jembellish.blogspot.com

Page 1

Then cut out your fabric. One large circle of the outer fabric. One large circle of the inner fabric Two smaller circles of the inner fabric: You will also need some thick plastic – a washed juice or milk bottle is fine – with a 10cm (4”) diameter circle cut from that (around mug size is good). Then you need some ribbon or cord for the drawstring, and any trims you would like to add.

Take the outer large circle and fold into quarters. Place a pin on two edges about 3cm in from the edge.

Open the circle out, and make a button hole where each pin is. This will be where the drawstring cord or ribbon feeds through when you’re done!

www.jembellish.blogspot.com

Page 2

Then place the two large circles, right sides together and pin around the edge.

I added a piping trim here, by pinning it between the two circles:

Then stitch all the way around the edges.

Now you need to snip a hole in the centre of the INNER fabric circle:

Then turn the circles right sides out, through the hole. www.jembellish.blogspot.com

Page 3

Repeat this process for the two inner circles:

Pin right sides together, stitch, snip the centre and turn right sides out.

Now place the large circle flat with the inner fabric facing up. Place the plastic circle in the centre over the hole you snipped, then place the smaller circle on top of that, with the hole facing down against the plastic.

Pin around the plastic circle to hold it in place:

www.jembellish.blogspot.com

Page 4

Then stitch around the circle, feeling with your fingers as you go to keep your stitching even with the edge:

Next you need to stitch the pockets. Stitch straight lines from the centre circle – to the outer edge of the smaller circle. Stitch slightly over the edge to make it a little stronger. I didn’t measure any of these pockets so they vary a little in size.

Now you need to stitch the casing for the drawstring. Stitch two rows of stitching all the way round the outside of the larger circle – one row on either side of the buttonholes you made earlier:

www.jembellish.blogspot.com

Page 5

So now you can thread your ribbon or cord through the casing using a large safety pin:

You will need two lengths of ribbon or cord. Thread one all the way round and out one buttonhole, and the other round and out the second button hole – so you end up with something like this:

Here I threaded the ribbon through, then cut it to the length I wanted the bag to be able to open to. Two 50cm (19.75”) lengths would be good; I made this one a little longer. To finish the edges off, take two small rectangles of the outer fabric (approx. 8 x 4cm (3.15 x 1.5”)). Fold each rectangle in half, right sides together and stitch down the sides, leaving the end open:

www.jembellish.blogspot.com

Page 6

Then turn this mini ‘pocket’ right sides out, and insert the ends of the ribbon or cord into it. Fold the ends in and stitch across the top to secure in place:

All done! Ready to fill up with jewellery!

www.jembellish.blogspot.com

Page 7