Freelander 2 – Side Bar Fitting Instructions Kit contents 2 x Side Tubes 4 x Inner Brackets ( Long ones for Front / Short ones for rear ) 4 x Outer brackets 4 x M6 Rivnuts / M6 bolts / M6 spring washers / M6 flat washers 6 x M8 bolts / M8 spring washers / M8 flat washers 4 x M12 nuts / M12 flat washers / M12 spring Washers ( for fixing bars to brackets )

Fitting Sketch

Freelander 2 Side Bar Fitting Instructions Rev1.0 Jan 2008

Page 1

Step 1 – Unscrew the 6 retaining screws on the underside of the Plastic sill cover. Step 2 – Pull the sill cover forward sharply to remove the sill cover from its plastic retaining clips. Step 3 – Drill out the pre marked areas at the front and rear of the sill cover with a 38mm drill.

Step 4 – Insert Rivnuts to pre-existing holes on the underside of the inner sill at front & rear.

Freelander 2 Side Bar Fitting Instructions Rev1.0 Jan 2008

Page 2

Step 5 – Mount Front Outer bracket as shown below with 1 x M8 bolt / flat washer & spring washer

Step 6 – Mount Rear outer bracket as shown below with 2 x M8 bolts / flat washer & spring washer

Freelander 2 Side Bar Fitting Instructions Rev1.0 Jan 2008

Page 3

Step 7 – Re-fit plastic sill cover and re-fit screw on the underside of the sill cover. Step 8 – Fit the inner brackets as shown below ( long bracket at Front / short bracket to rear )

Step 9 – Fit Side Bar using M12 flat washer / spring Washer and Nut – tighten hand tight only Step 10 – Check position of bar is correct – adjust if needed. Step 11 – Tighten bolts to 20Nm Care & Cleaning Periodically inspect bars to ensure all fittings are tight and secure. Replace product after damage or accident. Scratches can be removed by cleaning with rubbing compound and a buffing wheel. Polish with a metal polish or chrome cleaner.

Freelander 2 Side Bar Fitting Instructions Rev1.0 Jan 2008

Page 4